| G00 | Rapid Positioning | M00 | Program Stop |
| G01 | Linear Interpolation | M01 | Optional Stop |
| G02 | Clockwise Circular Interpolation | M02 | Program End |
| G03 | Anti-Clockwise Circular Interpolation | M03 | Spindle Rotation Clockwise |
| G04 | Exact Stop (Dwell) | M04 | Spindle Rotation CCW |
| G17 | XY Plane | M05 | Spindle Stop |
| G18 | ZX Plane | M06 | Tool Change |
| G19 | YZ Plane | M08 | Coolant On |
| G20 | Input in Inch | M09 | Coolant Off |
| G21 | Input in mm | M10 | Vice Open |
| G28 | Return to reference Point | M11 | Vice Close |
| G50 | Scaling OFF | M13 | Spindle Rotation Coolant on |
| G51 | Scaling ON | M14 | Spindle Rotation Coolant off |
| G73 | High Speed Drilling Cycle | M20 | ATC Arm in |
| G74 | Left Hand Tapping Cycle | M21 | ATC Arm out |
| G76 | Fine Boring | M22 | ATC Arm out |
| G80 | Canned Cycle Cancel | M23 | ATC Arm down |
| G81 | Spot Drilling | M24 | ATC Tool Clamping |
| G84 | Right Hand Tapping Cycle | M25 | ATC Draw Bar Releasing |
| G85 | Boring Cycle with Feed retraction | M27 | ATC Reset |
| G86 | Boring Cycle with rapid retraction | M30 | Program Stop and Reset |
| G88 | Boring Cycle | M70 | X-Mirror ON |
| G90 | Absolute Coordinate System | M71 | Y-Mirror ON |
| G91 | Incremental Coordinate System | M80 | X-Mirror OFF |
| G94 | Feed per Minute | M81 | Y-Mirror OFF |
| G95 | Feed per revolution | M98 | Sub-Program Call |
| G98 | Return to Initial point in a canned Cycle | M99 | Sub Program Exit |
| G99 | Return to R Point in a canned Cycle | | |